TurboLamik TurboLamik

Parameters / General

General

Parameters the XDF leaves outside any category, including the program selector grid that maps each program to its shift behaviour.

2 parameters: 2 documented.

2 parameters

Program Selector

# 0x45F8 8×8
The master table for the 8 driving programs. Each column is one program (P1-P8); the rows set its character: auto mode, upshift and downshift firmness, start and end gear, torque-reduction table, converter lockup, and AWD map.
Manual: The 8 modes See also: 0x1435 · 0x38A0
Detail

TurboLamik XDF

Automatic mode: 0-OFF, 1-Auto1, 2-Auto2, 3-Auto3 TIME shift UP: 0-Normal, 1-Sport1, 2-Sport2, 3-Neutral TIME shift DOWN: 0-Normal, 1-Sport1, 2-Sport2 ST. GEAR- Start gear from Neutral END GEAR- Last Gear before Neutral TQ.R.T- Torque Reduction Config 0-2 Lockup config, 0-2 AWD: 0-Normal, 1-S1, 2-S2, 3-OFF

From the official base maps what they contain, not what it does

Values differ between official base maps (6 distinct variants); across all 16 they span 0 to 3.

Address
0xD46 3398
Size
8×8 cells
Width
8-bit
Firmware
10.75, 10.77

Program Selector KickDOWN

# 0x4BDD 5×8
While kickdown is held, this table shadows the Program Selector: per program it overrides upshift and downshift firmness (Normal/Sport1/Sport2), the torque-reduction table, lockup config and AWD mode. Same row meanings as the main selector.
Manual: The 8 modes See also: Program Selector · 0x575B
Detail

TurboLamik XDF

TIME shift UP: 0-Normal, 1-Sport1, 2-Sport2, TIME shift DOWN: 0-Normal, 1-Sport1, 2-Sport2 TQ.R.T- Torque Reduction Table 0-2 Lockup config, 0-2 AWD: 0-Normal, 1-S1, 2-S2, 3-OFF

From the official base maps what they contain, not what it does

Values differ between official base maps (5 distinct variants); across all 16 they span 0 to 2.

Address
0x1E22 7714
Size
5×8 cells
Width
8-bit
Firmware
10.75, 10.77
10.75 name
Program Selector Kickdown

Names and groups follow the TurboLamik XDF. Values are not published here: open your own .bin in Map Studio to see what your map actually holds, and verify anything you change against the official manual.