Run a ZF 8HP behind any engine
The free community guide to the TurboLamik standalone TCU: wiring, the eight driving programs, torque setup, lockup and slip, and troubleshooting, plus a browser map editor. Everything you need to run a ZF 8HP behind any engine, in reading order.
What you'll find
Manual
Twelve chapters in reading order, from first power-up to launch control.
Pinout explorer
Every TCU and gearbox connector pin, filterable by layer, with function and wire convention.
ECU CAN integration
Exact CAN settings to connect Haltech, MaxxECU, Ecumaster, Holley, Link and more.
Troubleshooting
Search an error code or a symptom and get the likely cause and the fix.
Map Studio
Open your own .bin in the browser, see every table as a heatmap, edit and share. Open Map Studio ↗
Start here
New to the TurboLamik TCU? Begin with the first chapter →