TurboLamik TurboLamik

← All ECUs

MaxxECU → TurboLamik

Well supported

Built-in TurboLamik support, the cleanest integration: no raw CAN IDs to enter by hand.

CAN settings

  • Built-in MaxxECU integration
  • CAN speed 500 kbps
  • Requires MaxxECU firmware 10.73+

Notes

  • Set the CAN speed to 500 kbps on both the MaxxECU and the TCU.
  • Requires MaxxECU firmware 10.73 or newer.
  • The official manual does not publish raw CAN IDs for MaxxECU, the integration handles them.
  • Footbrake over CAN is not documented for MaxxECU. Wire the footbrake to pin 11 (A7).
  • Torque is calculated internally by the TCU. Verify it before adaptation.

Official reference: MaxxECU on manual.turbolamik.eu. Always confirm against the latest TunerPro driver files from download.turbolamik.eu.