TurboLamik TurboLamik

← All ECUs

Link G4 / G4+ / G4X → TurboLamik

Supported

Uses the TurboLamik CAN stream via a custom CAN setup in PCLink.

CAN settings

  • TCU stream v1 = CAN standard 6
  • TCU stream v2 = CAN standard 7
  • Custom CAN setup required

Notes

  • More involved than the native ECUs: you build the CAN setup yourself.
  • Import the Link CAN/DL file from download.turbolamik.eu where available.
  • The stream does not self-label its channels, so map them carefully.
  • Footbrake over CAN only exists on the v2 stream (CAN standard 7). On the v1 stream (standard 6) there is no brake bit, so wire the footbrake to pin 11 (A7).
  • Torque is calculated internally by the TCU. Verify it before adaptation.

Official reference: Link G4 / G4+ / G4X on manual.turbolamik.eu. Always confirm against the latest TunerPro driver files from download.turbolamik.eu.