TurboLamik TurboLamik

← All ECUs

DTAFast → TurboLamik

Check settings

Supported; minimum software version is the only published requirement.

CAN settings

  • Requires DTA software 8.0 or newer

Notes

  • Uses the TurboLamik v1 stream (CAN standard 6). The v1 stream has no brake bit, so wire the footbrake to pin 11 (A7).
  • Torque is calculated internally by the TCU. Verify it before adaptation.
  • Confirm the stream settings in the TunerPro XDF or with TurboLamik before relying on them.

Some settings for this ECU are not officially published. Verify in TunerPro before relying on them.

Official reference: DTAFast on manual.turbolamik.eu. Always confirm against the latest TunerPro driver files from download.turbolamik.eu.